Polar Electro E200 User Manual download pdf (Page 73)

ENG

WearLink Transmitter Battery

The estimated average battery lifespan of the transmitter

is 2 years (usage: 1h/day, 7 days/week). If your transmitter

stops working, it might be due to the battery running out.

To change the battery, you need a coin, sealing ring, and

battery (CR 2025).

1. Open the battery cover of the

connector by turning it counter-

clockwise with a coin from

the CLOSE position to the OPEN

position.

2. Remove the battery cover, lift the battery and replace it

with a new battery.

3. Remove the sealing ring of the battery cover and replace

it with a new ring.

4. Place the negative (-) side of the battery against the

bottom and the positive (+) side against the cover.

5. Put the cover on so that the arrow points to the OPEN

position. Make sure that the cover’s sealing ring is

placed correctly in its groove.

6. Gently press the cover deep enough so that its exterior

surface is on the same level as the connector’s surface.

7. Turn the cover with the coin clockwise so that the arrow

on the cover turns from OPEN to CLOSE. Make sure that

the cover is closed properly!

Note:

• In order to ensure the maximum life span of the connector’s

battery cover, open it only when you need to change the

battery. We recommend that you change the sealing ring of

the battery cover every time you change the battery. You can

get the sealing ring / battery kits from well-equipped Polar

retailers and authorized Polar Services. In the USA and

Canada: Additional sealing rings are available from an

authorized Polar Service Center only.

• Keep the batteries away from children. If swallowed,

contact a doctor immediately.

• Batteries should be disposed of properly according to local

regulations.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 81 82

No comments

Polar Electro E200 User Manual Page 73